Pansat 3500SD Digital FTA Receiver

The Pansat 3500SD FTA digital receiver is a new addition to the Pansat lineup for 2006. It replaces last years Pansat 3500S.

This new model adds 2mb of flash RAM (faster channel changing over last years model), 100 satellite programmable, 5000 channel memory, universal remote, component video out, SD memory card slot, 128MB SD memory card, and an embedded satellite smart card slot for current and future satellite programming with the use of a access card.

Embedded Smart Card Slot
1 smart card reader
SD-card interface	1 SD-card compatible memory card slot
Tuner/Channel
2 Input Connector	F-type, IEC 169-24
IF Input Frequency	950MHz to 2150MHz
IF Loop Throughout	950MHz to 2150MHz
IF Frequency	Zero-IF
Input Level	-65 dBm ~ -25 dBm
LNB Power	13/18VDC/500mA Max
DiSEqC Control	Version 1.3 Compatible
Band Switching	22KHz Tone
Demodulation	QPSK
System Rate	1~45 Msps (SCPC, MCPC)
Viterbi Decoding Rate	1/2, 2/3, 3/4, 5/6, 7/8
Reed Solomon Decoding	FEC:204, 188, t=8
DiSEqC	1.3 Compatible (STAB USALS)

MPEG Transport Stream & A/V Decoding
Demultiplex	According to ISO/IEC 13818-1
Input Stream	Max. 90Mbit/s
Aspect Ratio	4:3, 16:9
Video Resolution	720 x 576 PAL 720 x 480 NTSC
Audio Decoding	MPEG Layer I & II
Audio Mode	Single/Dual channel, Stereo, Joint Stereo
Audio Sampling Frequency	16/22, 05/24/32/44.1, 48kHz

Microprocessor & Memories
Main Processor	STi 5518 BVB, ST20 32 bit
CPU Clock	81 MHz (100 MIPS)
Flash Memory	2 Mbyte
SDRAM	16 Mbyte
EEPROM	32 kbit

Data Port
Connector	9 pin D-sub type
Protocol	RS232 Asynchronous
Data Rate	Max. 19,2kbps

RF-modulator
RF-Connector	750 Ohm, IEC 169-2 Male/Female
Frequency	CH 3:61.25 MHz Ch4:67.25 MHz
Output Channel	CH 3-4 for the Remodulator
TV Standard	NTSC-M
Preset Channel	changeable by Menu

Front Panel
4 Digits LED Display	Channel number display
8 keys	Power, Channel up/down, Volume up/down, OK, Exit, menu

Rear Panel
IF Input	F-type connector
IF Loopthrough output	F-type connector
6 Phone (Cinch)	Video, Audio L, Audio R, YpbPr
S/PDIF Optical
Skew 3 Push Terminal (5V, GND, Pulse
S-VHS
UHF
Modulator
RS232 Serial Port	9-pin D-sub Type
Y/Pb/Pr Digital Component Video Out

Remote Control
Type	Infra-red (carrier-freq: 38 KHz)
Battery	2 x 1.5V AAA Type

Power Supply
Input voltage	AC 90 to 250V~50/60 Hz
Type	SMPS (Switch Mode Power Supply)
Power Consumption	Max. 25W
Standby Power	<5W

Physical Specification
Size	290 x 200x 65mm
Weight (net)	2.1kg

Downloads Available:

Pansat 3500S/SD Default Software - Download

Pansat 3500S/SD Instructions - Download